Thingiverse
Elegoo Filament Guide
door 3dDust
21
Downloads
5
Likes
0
Makes
Hello,
I purchased a Elegoo Neptune 2 printer and it has a filament sensor on it that I don't see me using and it was screwed down right in front of the extruder so when I took it off the filament going in came in high and was rubbing on upper part of hole going into the extruder. I designed this bracket and used a bearing that is used on the Ender pro models and cost me $2.99. Maybe might work on other prints, not sure.
I purchased a Elegoo Neptune 2 printer and it has a filament sensor on it that I don't see me using and it was screwed down right in front of the extruder so when I took it off the filament going in came in high and was rubbing on upper part of hole going into the extruder. I designed this bracket and used a bearing that is used on the Ender pro models and cost me $2.99. Maybe might work on other prints, not sure.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
