Elegoo Neptune 3 Plus Simplify3D Printer Profile

This is my Simplify3D printer profile I've been creating to use with the new ELEGOO Neptune 3 Plus. It should also work just fine with Neptune 3 Pro and Neptune 3 Max, you just need to change the bed size on the "Output" tab (if you don't see that tab, then you need to click on "Show Advanced" on the bottom left corner of the dialogue box).

3 Pro: 235x235x280
3 Plus: 330x330x400
3 Max: 430x430x500

Those are the FULL bed X & Y sizes (ELEGOO advertises them as 10mm less as the "printable" area) but the actual PEI sheet are the sizes above. The reason I use the actual bed sizes is because in my start gcode I run a line down the left side to prime the nozzle.

NOTE 1 !!! I haven't needed to use anything on the "Additions" or "Support" tabs so those are stock Simplify3D!!

NOTE 2 !!! I print on a smooth PEI flex plate from Fulament (the backside of the ELEGOO included textured PEI plate is bare METAL and NOT PEI coated! I see A LOT of people think it is something other than bar