Elegoo Phecda Enclosure / Case

This is a simple build for a Phecda enclosure.

You need the following parts to also get:

- 3mm thick acrylic / plexiglas sheets (or Wood etc.) with the size 270x726mm (x2 for side pannels), 270x710mm (x2 for side pannels), 710x720mm (x1 for top plate)

- 16 screws with nuts (M4x12)

- a 120 mm fan and a suction hose with 100mm diameter


Build:

- First print the 4 "bottom foots". Align the side sheets into them, drill the holes and mount them with the screws.

- Then use the 4 printed "outside top triangle" as a template to dril the screw holes.

- mount the "inside top triangles" with screws trough the side sheets to the "outside top triangles".

- finally the top pannel will simply be layed down on the "inside top triangles", which perform as plattforms (mount a handle to the top pannel if needed)

- afterwards you can print the fan adapter und screw it to any sheet that fits you best


You can seal all corners and the fann adapter with silicone if neede