Thingiverse
Elektron Digitakt speaker mod
by atari0
1
Downloads
5
Likes
0
Makes
Inspired by the 18650 battery mod project (https://www.thingiverse.com/thing:4295923). Internal batteries are also requred for this mod to function.
A small box for two 3W 4Ohm d27x16mm speakers and an XH-A232 (TPA3110) amplifier. If you have installed Xoliul's battery mod and soldered the battery to the power input barrel jack socket you will now have power on that socket. You can drill a hole in the model corresponding to your power wire diameter and have it plugged into the power socket of your Digitakt. Same goes for the stereo jack. There is no power button or volume control as these can be controlled from the Digitakt.
The case uses the two remaining M4 VESA mount holes at the back of the device. It doubles as a rack keeping it in a comfortable inclined position.
Have fun!
A small box for two 3W 4Ohm d27x16mm speakers and an XH-A232 (TPA3110) amplifier. If you have installed Xoliul's battery mod and soldered the battery to the power input barrel jack socket you will now have power on that socket. You can drill a hole in the model corresponding to your power wire diameter and have it plugged into the power socket of your Digitakt. Same goes for the stereo jack. There is no power button or volume control as these can be controlled from the Digitakt.
The case uses the two remaining M4 VESA mount holes at the back of the device. It doubles as a rack keeping it in a comfortable inclined position.
Have fun!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
