Elektron Model Series Custom Knobs with Logos - v 1.1 (UPDATED)

*NOTE: I do not work for Elektron. This is an independent custom build and I am not selling it for money.

While I was replacing the button pad on my Elektron Model Samples, I realized my knobs were getting a bit worse for wear and that the text under the knobs was rubbing off from use. As I had been working on making my knobs more visible under a black light anyways, I found a design that fit and then added a brim/fillet for smoother turning and for a bit of mercy if cleanup is rough. The brim was necessary as too much circuit board is exposed with encoder knobs that are too narrow. They are a bit taller than the factory knobs but adjusting the Z-height of the models should not affect the fitting.

I also developed a custom logo system for when that text wears off. I have included a legend below. However, if that does not work for you, I have a blank knob file included so you can make your own designs as well as a blank knob with shorter brim for the 2 clickable encoders (See below).