Eleven Stranger Things Bookmark

This Hueforge is printed at 0.04 layer height. Please adjust your extruder setting to enable printing at this layer height. See below. If you would like to sell my Hueforges a Commercial Licence Subscription is available. Do not sell my prints without it please. If you do not have an AMS, just delete the filament changes and replace them with pauses instead. Then you can change filament manually when it pauses at the correct layer. Important:I have used a height range modifier in my print profiles for quicker printing. The layer swap numbers in the print profile will not match the ones written below in the print instructions. Do not worry about this.You CANNOT adjust the Z axis scaling on a Hueforge. It will not come out as intended. You can change the X and Y values to scale the picture up or down though.To ensure that the print looks the same as mine you must use the same filaments I did (listed below). If you do not, your results will not be exactly the same as shown. (It may still