Elfa rail clips

Designed to fit rails of Elfa frame to keep large wire baskets in their slot. Tired of them constantly falling out onto the basket below. This is only for the wire baskets with a large space between wires, won't work for the fine mesh variety.

Printing:

I used PLA.

Infill 30%, cubic. Can go higher of course for heavier items.
Layer height 0.3
Walls 2
Flow 100%

Add to build plate, select and multiply to number needed. Would advise printing one first then adjust x or y axis as needed for your frame and baskets.


Elfa thin, faster print
Elfa wider for heavier loads

I prefer to print multiple thin and apply to one of the last 2 openings on the back of the basket over the rail.

I place the cup of the C toward the inside of the basket with the hooked edge toward the outside. It works either way. Or, put one on both sides to provide more stability.

Place on one of the last couple holes of the basket in the back. I use the last 2 holes on each side.



I have