Elgato Stream Deck MK2 Adjustable Mount

This is an adjustable mount for the Elgato Stream Deck MK2. It allows you to adjust the tilt angle for better ergonomics. I've tested this print with both Bambu matte PLA and Sunla PLA and the parts print great, however I would recommend to print this with the Bambu filament as the part finish and tolerance end up slightly better than the sunlu. It is also printed on the cool plate. For hardware, you will need the following:-Bezel: [Qty 4] M3 socket head cap screws, or button head screw, 12mm long. -Base Mount: [Qty 1] M3 socket head cap screws, or button head screw, 30mm long. [Qty 1] M3 Nylock nut, or M3 wing nut. To assemble the unit, start by installing the Stream Deck into the back cover. A bit of pressure will be required and the stream deck will fit snugly. Then install the front cover and the 4 M3x12 screws. The screw will self tap into the back cover. Then slide the assembly into the base mount slot and press the M3x30 screw through. It should go through by hand, but if yo