Thingiverse
EllPro - Gamma World Warbot
von EllPro
13
Downloads
7
Likes
0
Makes
I wanted to make up a warbot for my Gamma World (4e) game, but I couldn't find a good turret for the top until I found Evanogainen's. Doing up the rest was easy.
There's a 3mm hole in the bottom of the bot for a float stand. I made it that large because it can be a bit wobbly, sort of like a drunk cat that happens to be a 5 ton robotic war machine, and I found a nice and thick stand will hold it nicely. The bottom of the bot should be about 10-15 mm above the tabletop.
Edit - Floating stand now included, 6/4/20
The holes in the back are air and/or drain holes. If you don't want them, just stick a support in it with a little resin and then UV it shut. If you're using a filament printer, I'm sure you can think of something.
Come by my Patreon for a special gift, just as a thank you for visiting! Also, please consider joining. I'm disabled, so this is one of the few ways I can bring in any income.
https://www.patreon.com/EllPro
There's a 3mm hole in the bottom of the bot for a float stand. I made it that large because it can be a bit wobbly, sort of like a drunk cat that happens to be a 5 ton robotic war machine, and I found a nice and thick stand will hold it nicely. The bottom of the bot should be about 10-15 mm above the tabletop.
Edit - Floating stand now included, 6/4/20
The holes in the back are air and/or drain holes. If you don't want them, just stick a support in it with a little resin and then UV it shut. If you're using a filament printer, I'm sure you can think of something.
Come by my Patreon for a special gift, just as a thank you for visiting! Also, please consider joining. I'm disabled, so this is one of the few ways I can bring in any income.
https://www.patreon.com/EllPro
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
