Elvira Lithophane

It's a bit early for pumpkin spice season but, there's no time like the present to get your mood lighting in your print room ready for Halloween! The Misstress of the Dark's picture was made to fit EScvn54's “Desktop Lithopane Frame”.Print with white filament at 100% infill with a layer rate selected for high detail and this STL will yield a near photo-quality lithopane. Note while the case says it will fit 120 x 90 lithopanes that is a really loose fit.. This pane will print slightly larger. About 122 x 92 for a tighter fit.After you print the case parts, assemble the bottom using 2 M3x8mm screws. There are many ways you can light this. A hole in the side allows for the pass-through of a power wire. Mine lights through this unit from Harbor Freight. It's battery powered, and the brightness level and effects are adjustable with a remote control. BONUS! It doesn't cost that much!I have put together a series of lithophanes that all fit the same holder. You can swa