Embedded House Display Stand

This is a simple idea i had after my print of a house had failed halfway. A simple stand for miniature figurines, busts, statues, sculptures, anything, really. Settings I recommend for a perfect print - - retraction speed - 65, de-rectraction - 55. - 15% infill (I used lightning) - anything less than 8% will break extremely easily. - Support is needed for the chimney, I used slim tree support. Filament used - 26.24g, or 8.78 meters. Should take about 66 minutes to print at 100% speed - Slowed down first layer for better adhesion. Credits to dxdiag for the inspiration.