Embers

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm  The Model is 200x200mm in size. You can change X and Y but Z must remain the same.  You may print at higher layer heights below the Min Depth of 0.48mm  Actual Depth is 2.2mm Filaments Used: PLA BambuLab Basic Orange Transmission Distance: 5 PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA PolyLite Grey Transmission Distance: 1 PLA PolyLite White Transmission Distance: 5 This print uses 6 unique filaments. Substitute as needed. Swap Instructions: Start with Orange At layer #7 (0.64mm) swap to Red At layer #13 (1.12mm) swap to Black At layer #18 (1.52mm) swap to Blue Gray At layer #22 (1.84mm) swap to Grey At layer #23 (1.92mm) swap to White for the rest.