Emek Stock

*UPDATES AT BOTTOM*

This print gives you 6 options of stock length on a Planet Eclipse EMEK. Print the remixed extended BMC back cap and install it onto your emek bolt. Next decide on the stock length you want and print. Long stock is 220mm, short is 200mm. Add an M5 nut and 20mm length bolt. The anti-rotation bars will set the length of pull. If you want a more rubbery stock feel, print the grip in TPU and slip it over the end of your plastic stock.

Stocks - Can print with supports, shouldn't be necessary. If you have adhesion problems with the bottom of the stock, drag it down in the Z axis until its a flat print.
Bar - Normal supports required.
Cap - Could use supports in the center.
Grip - Print in TPU, no supports. Use low infil, cross 3D should give good flexibility.
Gripv2 - fancier, not as soft. print with supports.

I reuploaded the stocks when I added the TPU grip. I'm using a #4 x 1/2" screw to secure the grip. It may not be necessary as the grip holds pretty ti