Thingiverse
EMERGENCY HUNGER!
von bwillz85
38
Downloads
33
Likes
1
Makes
Co-workers gave me a hard time about how Hangry I can get. I figured "Safety First" ;) The only issue with it is the tolerances between the dove tail sections. I have attached .f3d as well as an Fusion 360 Link for download. If anyone knows how to correct the tolerances for 3D printing please make the adjustments and send it to me and I will upload. I am still a novice to F360.
Please post any makes or remixes! I'd like to see them.
Picture Support came from: https://www.thingiverse.com/thing:2104586. -Thank You
Assembly Instructions:
1. Print all the pieces.(Back Panel Print: For multi-color on letters, change filament at 3.5mm)
2. Check fitment of the Dove Tail joints. Make adjustments if necessary.
3. Assemble the bottom panel and both side panels.(Note: I used a clamp to hold the sides against the bottom panel for the next step.)
4. Slide the back panel down along the back sets of grooves.
5. Fit the top section on. (Make sure that the slot on the top pa
Please post any makes or remixes! I'd like to see them.
Picture Support came from: https://www.thingiverse.com/thing:2104586. -Thank You
Assembly Instructions:
1. Print all the pieces.(Back Panel Print: For multi-color on letters, change filament at 3.5mm)
2. Check fitment of the Dove Tail joints. Make adjustments if necessary.
3. Assemble the bottom panel and both side panels.(Note: I used a clamp to hold the sides against the bottom panel for the next step.)
4. Slide the back panel down along the back sets of grooves.
5. Fit the top section on. (Make sure that the slot on the top pa
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
