Thingiverse
Emergency Stop Button Cover
by rdalen
14
Downloads
12
Likes
0
Makes
A small cover for a emergency stop button with 16mm shaft diameter.
It is inspired by the [design of Chris Gilletti](https://www.thingiverse.com/thing:3693084) However that design didn't give a nice result on my printer. So I made an alternative design.
The bottom part fits on aluminum 4020 profiles with two M4 or M5 bolts and T-nuts.
In the bottom part I made screw taps for four M3x10mm bolts to attach the middle part of the case. The top part is fastened just on friction with 0.4mm clearance.
The emergency button interrupts the power wire between the power supply and the printer control board
It is inspired by the [design of Chris Gilletti](https://www.thingiverse.com/thing:3693084) However that design didn't give a nice result on my printer. So I made an alternative design.
The bottom part fits on aluminum 4020 profiles with two M4 or M5 bolts and T-nuts.
In the bottom part I made screw taps for four M3x10mm bolts to attach the middle part of the case. The top part is fastened just on friction with 0.4mm clearance.
The emergency button interrupts the power wire between the power supply and the printer control board
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
