Emergency Stop switch mount for AM8

This is a simple housing for an emergency stop button/power switch for the AM8. Mounts directly to the extrusion wherever you want it using two extra t-nuts and M5 bolts left over from the build. It has a relief in the back for the wires to route under the frame while still sitting flush with the table. I used slightly shorter square rubber feet on my build so my printer may sit a mm or two lower than it would if you used the feet from the AM8 BOM. Measure before printing and since it prints upside down you can slice it to stop printing the model at whatever height is appropriate for your printer.

For the switch I used a cheap uxcell red mushroom emergency stop switch $5.36 on Amazon(https://www.amazon.com/gp/product/B0094GM004/ref=oh_aui_detailpage_o09_s00?ie=UTF8&psc=1) But any 22mm stop switch should work. I left a decent amount of extra room for wiring and switches of different dimensions.