Slicer Discord
Emergency Tums Container – 3D printable model from Thingiverse Thingiverse

Emergency Tums Container

26 Downloads
22 Likes
1 Makes
Go to Model
Now that I have a grand old time with some bad acid reflux, I find it necessary to keep a bottle of 1000mg Tums on me at all times. Sometimes it is inconvenient to keep a whole bottle on my person when I will most likely only need two tablets. That's why I made this container, it is minimalistic and can easily be kept in one's back pocket to keep two tums ready at a moment's notice.
This is intended to be used with small 3mm diameter x 1.5mm deep neodymium magnets, which can be purchased cheap just about anywhere. Just use some super glue to hold em in place.
I got mine here, which are uncommon on their website because it is a bulk surplus purchase, and they usually have imperial measurements only.
http://www.kjmagnetics.com/proddetail.asp?prod=ZD4
1/8" x 1/16" is the closest imperial equivalent and should also work, may be a bit of a tighter squeeze but the tolerance of the hole diameter should still be good enough for that. So for anyone looking to make a smaller and cheaper orde
Source
Thingiverse
What you need to print this: Intermediate Low confidence
Why?
significant post-processing
Single piece Hardware needed
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 2/3
Printer
FDM / FFF
File format
STL
Material
PLA
Post-processing
Gluing, Hardware
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

PteroDancer also publishes on

29 additional models across 1 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection