MakerWorld
Decor
Go to Model
Emoji Magnet Set
407
Downloads
142
Likes
175
Makes
A set of 16 emoji magnets with all different faces and emotions. Each magnet is 42x42x5mm. The file is set up facing down for optimal and smoothest printing, but can be flipped over if preferred. No support is needed for the magnet slot if flipped. The magnet slot is made so a 6x3mm round magnet will be flush against the back, and there is a little extra room around the sides in case of filament expansion or printer settings being a bit off. You can also use a 6x4mm magnet if you want it to stick out a bit to grab off your surface easier. I recommend using e6000 glue or gorilla gel glue to stick in the magnets. Magnets I used: https://www.amazon.com/gp/product/B07KZQGWNN/ Images shown were printed with a .4 nozzle. If you like my work please consider a tip! https://buymeacoffee.com/vogel3dcrar Membership
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
