Thingiverse
Emoji Pilot
by k3lf
15
Downloads
9
Likes
1
Makes
I received a little rubber Emoji man as a favor at a birthday party. As soon as I saw it I started planning how to print a waist-up figure for one of my RC airplanes. If you saw my flying skills you would understand the look of fear on this guy's face. It probably reflects the look on my face after each flight.
The head is 44mm wide. At that scale it fits nicely in my 64" MSX 3d plane from Extreme Flight. You should be able to scale it up or down to fit all but very small planes. With a shell thickness of 4 layers and 15% infill this came out at 15 gm when printed in PLA. You will need to use supports for the arms and under the head and torso and these areas will need a little clean-up.
The head is 44mm wide. At that scale it fits nicely in my 64" MSX 3d plane from Extreme Flight. You should be able to scale it up or down to fit all but very small planes. With a shell thickness of 4 layers and 15% infill this came out at 15 gm when printed in PLA. You will need to use supports for the arms and under the head and torso and these areas will need a little clean-up.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
