Empty Tomb Easter Night Light (BETA Files)

This is a fun design to make throughout the Easter month. It is ready to print but need some tweaks. I would love to have feedback on what would be better.Check out my other models on Makerworld or Printables Parts:1x to 4x, 3mm LEDwireglue3D printed partsaluminum Foil2x AAA batteries 6mm x 20mm x 10mm limit switch (H x W x D) For wiring - 1. Cut a piece of aluminum foil. Fold the sheet over and over till it is about 8-10mm wide (The thickness can vary as long as the batteries still fit). Now repeat this 3x. 2. For the bottom piece of aluminum foil in the battery compartment, make sure it will fit in the slot. Finally put the foil in the back slot.3. For the front battery connector they need to fold over into a slot. When you have made sure they fit take them out and poke a hole through both pieces (this will be where the wire goes) and do not put them back yet.4. Take 1-4 3mm LED's and wire the all the positive sides together and all the negative sides together (I only used 2 LED&