Thingiverse
EMT Brackets
von markz
21
Downloads
8
Likes
0
Makes
A set of brackets that fit US EMT 3/4 inch conduit. Use them with EMT to mount whatever you need to . Cameras, Lights. Whatever. Enjoy.
Use a fairly good infill for strength.
I recommend a high performance PLA such as Raptor PLA by MakerGeeks for this parts.
See my EMT Projects playlist on youtube:
https://www.youtube.com/watch?v=SHjwDlyrrwA&list=PLKn-nL8_bEaA5HHMGGfKuYXJgLDr5-q3W
Update 9/17/18 - I no longer recommend the Raptor PLA. It deforms over time. Use a regular PLA and tap on gently. Print one and test fit to see if your prints need to be adjusted a little for good fit.
Update 9/17/18 - Added Heavy Duty Camera mount V2 (V1 was a prototype and not included in this thingy) Needed a heavier duty camera mount for the heavy Sony 4K camera.
Use a fairly good infill for strength.
I recommend a high performance PLA such as Raptor PLA by MakerGeeks for this parts.
See my EMT Projects playlist on youtube:
https://www.youtube.com/watch?v=SHjwDlyrrwA&list=PLKn-nL8_bEaA5HHMGGfKuYXJgLDr5-q3W
Update 9/17/18 - I no longer recommend the Raptor PLA. It deforms over time. Use a regular PLA and tap on gently. Print one and test fit to see if your prints need to be adjusted a little for good fit.
Update 9/17/18 - Added Heavy Duty Camera mount V2 (V1 was a prototype and not included in this thingy) Needed a heavier duty camera mount for the heavy Sony 4K camera.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
