Thingiverse
EMT Linear Motion Components
door WestTexasHerder
5
Downloads
6
Likes
0
Makes
This is a build utility system based on half inch EMT. It includes linear motion components as well as several EMT mounts and a shaft collar. The clamps and truck holes are meant to be tapped 1/4-20.
You can use it for low precision slides, hinges, and custom structures. You can get a tighter fit by scaling the sliding components.
Print them with the EMT holes facing up and then give the EMT a quick hand sanding to get any crud off and then you are good to go.
You can use it for low precision slides, hinges, and custom structures. You can get a tighter fit by scaling the sliding components.
Print them with the EMT holes facing up and then give the EMT a quick hand sanding to get any crud off and then you are good to go.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
