Thingiverse
Enamel pin POS stand
by siren10101
10
Downloads
8
Likes
0
Makes
*print with feet parallel to bed*
This POS is designed for displaying a set of up to 7 pins on their display backing and one permanent display unit on the foot.
Great for using on a counter top or for your hero product at markets. easily re-stocked.
Suitable for standard business card backers (91x55mm).
The base is hollow and should be printed with support, ballast weights can be glued on the inside of this section to keep the unit solid and steady, while small feet are provided for adding grippy feet.
The uprights allow for backers to rest in a upright angle while having room to not rub against each other potentially causing the catches to scratch the surface of your product.
This POS is designed for displaying a set of up to 7 pins on their display backing and one permanent display unit on the foot.
Great for using on a counter top or for your hero product at markets. easily re-stocked.
Suitable for standard business card backers (91x55mm).
The base is hollow and should be printed with support, ballast weights can be glued on the inside of this section to keep the unit solid and steady, while small feet are provided for adding grippy feet.
The uprights allow for backers to rest in a upright angle while having room to not rub against each other potentially causing the catches to scratch the surface of your product.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
