Thingiverse
Enclosure corner support
von dr251
18
Downloads
14
Likes
0
Makes
V1 corner support for a enclosure, in my case a enclosure for the 3D printer Ender 3
########################################################################
V2
On version 2 there is a improvement of the big side, it was a bit soft and not very strong to contain the horizontal side. I modified the horizontal side with a new vertical line to make more strong the support
########################################################################
V2
On version 2 there is a improvement of the big side, it was a bit soft and not very strong to contain the horizontal side. I modified the horizontal side with a new vertical line to make more strong the support
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
