Enclosure for LoRa Button (parametric)

This is an enclosure I designed for the [Lora Button board by Iotdevices](https://www.tindie.com/products/iotdevices/lora-buttoninterrupt-node-arduino-compatible/).

See also [github.com/crox-net/lora-button-example](https://github.com/crox-net/lora-button-example).

I assembled it as follows:

1. insert the screws in the "lid" part, secure them with tape (I used M2.5 x 20 mm screws, M3 should work too)
2. place the battery inside the compartment with wires sticking out
3. place the board on top of the battery, connect the wires
4. place the box on top, flip around, fasten the screws

Look at the pictures for some details.

I use a 4x20x25 mm 150 mAh LiPo battery that I got from [ShopOfThings](https://shopofthings.ch/shop/prototyping/power/batterie-lipo-3-7v-500mah/). For people outside of Switzerland you can get them from [Aliexpress](https://s.click.aliexpress.com/e/_Ac16re) for instance.

Note that I didn't solder any headers, I used a [clamp with pogo pins](https://s