Enclosure for STC-1000 temperature controller

Angled two-part enclosure for an STC-1000 temperature controller. Accommodates the clips on the side of the temperature controller to lock it in place. Wires can be fed in through a small opening in the rear. Can be bolted onto an optics- or air-table, using two M6 bolts. Hole-spacing is 25mm, so fits standard metric optics tables, but imperial users may have to resort to only using one bolt.

Lid should form a tight press-fit onto the housing. I recommend to print the main enclosure standing upright on its back, so the foot angles away.