Enclosure Pass Thru AMS

A 4 port pass through (bridge) to allow filament to go from the AMS Lite a top my enclosure to the printer inside my enclosure. Parts Needed:4x PC4-M6 Fittings4x PC4-M10 Fittings1 M4x6x6 Heat Insert1 M4x8 Hex Socket ScrewTools Needed:Coping Saw or similarWood Rasps/Files1/2in Counter Sink Bit10mm Socket3/32in & 7/64 Bit or 2,5mm Bit (3mm may work but I haven’t tested)Flush Cutters or similarPTFE Tubing (I used 2mm ID x 4mm OD and 3mm ID x 4mm OD)Install:The main part is pretty self explanatory. Figure out where you want it, use some double sided tape to stick the jig in place and drill a hole(s). Then use the coping saw or similar to cut out the shape. Depending on how good you are with it (I wasn't) you may need some wood rasps and files to shape and clean up the opening until the ‘bridge’ fits. This is designed for use with an IKEA Lack table enclosure so it is 50.5mm long, not including the flange at the top and should fit near perfectly. I uploaded the Solidworks file with, wha