Enclosure PMMA, MPSM

This is an PMMA (plexiglas) based enclosure for MPSM mini V1, with a scale of ~40x40x40cm. This will cost less then 50€. I've decide to spare out the filament roll, but its up to you to do same way or include the filament roll into the enclosure.

You need:
- 3x 40x40cm Plexiglas plates with 3mm thickness
- 2x 38x40cm Plexiglass plate
(i bought mine at local store, bought 5x 40x40 and cut off 2 plates by 2cm)
- 20x M2 8mm screw with nut
i bet to use only adhesive tape will work too (but minimum for the door you will need 4 screws)
- adhesive tape
- cutting machine (dremel or similar)

At first print the uploaded parts:
8x connect_corner
3x connect_corner_bottom
2x connect_door_4_hülse
1x connect_door_3_2
1x connect_door_2
1x connect_door_pin

Then mark on the left plate the area for your power cable, for the spool holder and filament way. cut them out by dremel (be carefull dont cut your fingers by the machine or plexiglas plate). For assembly start with corner botto