Enclosure with IKEA LACK

This project proposes a method to create your own enclosure using the IKEA LACK table as a base and wooden or plexiglass panels according to your needs. The peculiarity of this enclosure is that it has sliding walls, obtaining high accessibility to the printer and reducing the complexity of assembly. There are no hinges and magnets. The front and right sliding doors slide in opposite directions, so as not to obstruct the operator when opened. A screw-on foot with a non-slip rubber (TPU) bottom can be added to the feet, allowing you to adjust the height, further stabilizing the table and reducing vibrations. The upper sliding guides are fixed by the screw of the table legs, so no modifications are necessary.While the lower guides (feet) are fitted into a square seat which has a hole that can be used to insert a screw and screw the foot to the lower part of the table leg, giving greater stability to the structure.There is also a light cable holder, which can optionally be printed separat