Ender 2 Pro BLTouch

# Ender2Pro-BlTouch
BLTouch bracket for the Ender2 Pro

## Installation

This should work with the M2.5 nuts/screws provided with the BLTouch _or_ you can use M3 screws (with no nuts).
Note: When using M3 screws, you will be tapping directly into the plastic. It works well and that is how I installed mine

1. Remove the Z-Sense plug from the board
1. Wire up the BLTouch to the 5 port header on main board
The Brown and Black wires are both ground, you can join them to make wiring simpler
I used a proper [JST from Amazon](https://www.amazon.com/dp/B06ZZ45G7G/ref=cm_sw_em_r_mt_dp_CYFAK1BVFZH8YKFFS9SW?_encoding=UTF8&psc=1)
Marlin firmware should automatically detect the BLTouch.
You will then need to calibrate the Z offset. On my machine the Z offset is -2.1mm

Installing a BLTouch with this bracket will shift your X axis by 10mm.
Creality [has not yet released](https://github.com/Creality3DPrinting/Ender-3/issues/76) official configuration files