Thingiverse
Ender 2 - X Gantry stabilizer
door johnchiko
1
Downloads
0
Likes
0
Makes
I have a Direct Drive mount on my Ender 2. Got Tired of my X gantry moving every time i pressed the extruder handle to load/unload filament.
Made this to connect between the factory extruder mount and the 2020 profile.
The connecting bolt hole to the 2020 profile are 0.5mm higher than the center of the slot on purpose - to create some positive pressure and keep the gantry level.
M4 screws i believe 25mm... M4 t nuts...
Added a couple of holes on the bottom of this part to screw in a LED holder.
Now I can push on my Gantry and there is no more movement of the profile.
Made this to connect between the factory extruder mount and the 2020 profile.
The connecting bolt hole to the 2020 profile are 0.5mm higher than the center of the slot on purpose - to create some positive pressure and keep the gantry level.
M4 screws i believe 25mm... M4 t nuts...
Added a couple of holes on the bottom of this part to screw in a LED holder.
Now I can push on my Gantry and there is no more movement of the profile.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!