Thingiverse
Ender 3 Angled Spool Mount (No Additional Hardware)
von GlobalDisruptor
10
Downloads
6
Likes
0
Makes
This is a remix from the design by epiic. (https://www.thingiverse.com/thing:5686019)
The original design called for an m5 screw and nut to mount to the printer, this remix mounts without any additional hardware by replacing the end cap on the top extrusion and slotting into the v-slot along the back, its a friction fit and works well.
It will print without support in the provided orientation on a stock ender 3.
Use the original spool mount and hardware to attach to this part, then this part will attach to the printer.
The original design called for an m5 screw and nut to mount to the printer, this remix mounts without any additional hardware by replacing the end cap on the top extrusion and slotting into the v-slot along the back, its a friction fit and works well.
It will print without support in the provided orientation on a stock ender 3.
Use the original spool mount and hardware to attach to this part, then this part will attach to the printer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
