Thingiverse
Ender 3 basic filament guide
von Rodriprinter
10
Downloads
6
Likes
0
Makes
The piece has been created trying to be as simple as possible.
The aim is to prevent the filament from rubbing on the spindle of the Z axis.
I have used PLA and the resistance is more than enough.
In my case, a layer height of 0.1 was given, although such a high resolution is not needed at all.
La pieza ha sido creada intentando que sea lo más sencilla posible.
Se trata de evitar que el filamento roce sobre el husillo del eje Z.
He utilizado PLA y la resistencia es más que suficiente.
En mi caso se ha dado una altura de capa de 0.1 aunque no se necesita en absoluto una resolución tan alta.
The aim is to prevent the filament from rubbing on the spindle of the Z axis.
I have used PLA and the resistance is more than enough.
In my case, a layer height of 0.1 was given, although such a high resolution is not needed at all.
La pieza ha sido creada intentando que sea lo más sencilla posible.
Se trata de evitar que el filamento roce sobre el husillo del eje Z.
He utilizado PLA y la resistencia es más que suficiente.
En mi caso se ha dado una altura de capa de 0.1 aunque no se necesita en absoluto una resolución tan alta.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!