Thingiverse
Ender 3 CA601 Bed Mount Camera Arm
par T1nker
19
Téléchargements
9
Likes
0
Makes
I designed this as a remix of my previous bed-mount camera arm when I upgraded my camera. The arm can be printed at 0.2mm layer height but the screw prints better at 0.1. The CA601 camera is larger than the C270 but also has a larger FOV so I increased the angle of the arm to better fit within the LACK enclosure.
To install, remove the bed height adjustment wheels from all four corners of your print bed, Be careful to not lost your springs. Slide the camera mount on one corner of your bed and align the holes on the mount with the hole used by the bed screw. The mount is made to fit around the spring so don't remove the spring. Run the bed screw back through the holes so that they pass through the camera mount and print base plate. Screw the adjustment wheels back down far enough so your printer nozzle won't destroy your print bed like I did mine.
Then pass the screw through the back of the arm and screw it into the screw hole on the bottom of the camera as shown in the side vie
To install, remove the bed height adjustment wheels from all four corners of your print bed, Be careful to not lost your springs. Slide the camera mount on one corner of your bed and align the holes on the mount with the hole used by the bed screw. The mount is made to fit around the spring so don't remove the spring. Run the bed screw back through the holes so that they pass through the camera mount and print base plate. Screw the adjustment wheels back down far enough so your printer nozzle won't destroy your print bed like I did mine.
Then pass the screw through the back of the arm and screw it into the screw hole on the bottom of the camera as shown in the side vie
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
