Thingiverse
Ender 3 Cable Clips
von Holspeed
32.7k
Downloads
17.9k
Likes
274
Makes
Remix from jn-gr's ribbon cable clip for the Ender 3 - https://www.thingiverse.com/thing:2880021
The original clips are good but quite a loose fit and can be very difficult to get off if need be. These tweaks solve both issues and, as a bonus, you can use them on the PSU power cable as well.
The clip now has 45 degree fillers on the inside of the arms as well as small tags on the outside. To remove, just place a flat blade (screwdriver) behind the tag and lever against the aluminium extrusion - the clip will pop off.
The clip has also been modified to accept the 2 x 3mm power wires from the PSU.
Also included is a 90 degree clip, designed to anchor the ribbon cable where it crosses an extrusion. See photos.
This clip has shorter arms than the other one (therefore less flex) and consequently it's a bit harder to get on and off.
The clips attach to the centre section of 4040 aluminium extrusion so will suit any printer with that size framing.
Print on their side as per t
The original clips are good but quite a loose fit and can be very difficult to get off if need be. These tweaks solve both issues and, as a bonus, you can use them on the PSU power cable as well.
The clip now has 45 degree fillers on the inside of the arms as well as small tags on the outside. To remove, just place a flat blade (screwdriver) behind the tag and lever against the aluminium extrusion - the clip will pop off.
The clip has also been modified to accept the 2 x 3mm power wires from the PSU.
Also included is a 90 degree clip, designed to anchor the ribbon cable where it crosses an extrusion. See photos.
This clip has shorter arms than the other one (therefore less flex) and consequently it's a bit harder to get on and off.
The clips attach to the centre section of 4040 aluminium extrusion so will suit any printer with that size framing.
Print on their side as per t
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
