Thingiverse
Ender 3 cooling angled
von njosef
14
Downloads
9
Likes
0
Makes
Two models are designed for plexi glass (thickness 2 mm) encloser in Lack.
1. is entrance modul with thread for tube (two small support necessary for lock mechanism)
2. is securing nut (no support)
Next two models are for cooling of electronic board on Ender 3.
1. normal cooling entrance with plug (no support)
2. angled cooling pipe for tube (support for locking mechanism only)
1. is entrance modul with thread for tube (two small support necessary for lock mechanism)
2. is securing nut (no support)
Next two models are for cooling of electronic board on Ender 3.
1. normal cooling entrance with plug (no support)
2. angled cooling pipe for tube (support for locking mechanism only)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
