Ender-3 Cura Bed Mesh

Safely use the Ender-3's full 235 mm bed in Cura
============================================
[aso works in Cura 4.1]

Note: this will not prevent the machine from hitting the clips, rather it provides you with a visual of the location of the bed clips in Cura's preview.
Just make sure you line up the clips with the adjuster screws for this to be accurate.

Step one is the only required step to make this work. The others just make it more accurate and allow use of the entire bed.

1.
Place the STL file here:
"C:\Program Files\Ultimaker Cura 4.0\resources\meshes\creality_ender3_platform.stl"

2.
In Cura's "Machine Settings" set the bed X and Y to 235 mm.

3.
For this to be 100% accurate, I recommend calibrating your workspace offsets and perhaps even your endstops. The offsets I use are:
X: 2
Y: -2
Z: 0

This can be done by printing ClipTest VERY SLOWLY which should print from edge to edge (233.7 mm to be safe). Then measure the difference between where it print