Thingiverse

Ender 3 Direct Drive Cable Lock

by carl_olson

18 Downloads

22 Likes

0 Makes

I recently printed something to move my extruder motor on my Ender 3 to the print head, thus making it a direct drive unit. After doing some cable management on the back side of the printer I was unhappy with the space left behind from the stock extruder mount. Not to mention that I was using a zip-tie to secure the hot end and extruder cables with strain relief for the head to move freely.

So of course... I made something to print. :)

This cable lock can be printed upside down without supports. Once printed, align the cables with the cutout in the cable lock. Next, align 4 pegs with the screw holes for the stock extruder location. Press the center circle from cable lock into the large center circle from stock extruder location until cable lock is flush with the mount. It is meant to be a press fit so it may be a snug fit. This is to ensure the cables are held securely.

cable cable clip cable guide cable holder cable management clamp clip creality ender 3 direct-drive direct drive direct drive extruder Direct extruder Ender Ender3 Ender 3 guide holder Lock management robust cable cable clip cable guide cable holder cable management clamp clip creality ender 3 direct-drive direct drive direct drive extruder Direct extruder Ender Ender3 Ender 3 guide holder Lock management robust

Source

Thingiverse

What you need to print this: Beginner Low confidence

Why?

no supports

Support-free Single piece Hardware needed

Supports 0/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer