Thingiverse
Ender 3 Drawer
von Crelicx
89
Downloads
52
Likes
0
Makes
Drawer that mounts to the left rail on Ender 3 to provide extra storage. (Should fit any 40x40mm v-slot rail)
*NOTE The provided "RailTestFit" can be used to verify that this part won't interfere with your print head. Additionally I used the Skull Knob from DanielDo at 40% size in my picture, link below.
Time: (PursaSlicer, PLA, 0.2mm Layer Height, 10% Infill)
Total Single Drawer: 10.77 hr
Total Double Drawer: 12.07 hr
--
Rail Test Fit: 20 min or 0.33 hr
Drawer Case: 6.85 hr
Case Divider: 49 min or 0.82 hr
Whole Drawer With Handle: 3.92 hr
Half Drawer With Handle: 2.2 hr
Whole Drawer Without Handle: 3.87 hr
Half Drawer Without Handle: 2.15 hr
Specifications:
x-axis: 40.24mm
y-axis:108.648mm
z-axis: 55.33mm
Skull Knob:
https://www.thingiverse.com/thing:4604907
*NOTE The provided "RailTestFit" can be used to verify that this part won't interfere with your print head. Additionally I used the Skull Knob from DanielDo at 40% size in my picture, link below.
Time: (PursaSlicer, PLA, 0.2mm Layer Height, 10% Infill)
Total Single Drawer: 10.77 hr
Total Double Drawer: 12.07 hr
--
Rail Test Fit: 20 min or 0.33 hr
Drawer Case: 6.85 hr
Case Divider: 49 min or 0.82 hr
Whole Drawer With Handle: 3.92 hr
Half Drawer With Handle: 2.2 hr
Whole Drawer Without Handle: 3.87 hr
Half Drawer Without Handle: 2.15 hr
Specifications:
x-axis: 40.24mm
y-axis:108.648mm
z-axis: 55.33mm
Skull Knob:
https://www.thingiverse.com/thing:4604907
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
