Thingiverse
Ender 3 E-Step Calibration Brackets
von MechanicLyfe
8
Downloads
2
Likes
0
Makes
Ender 3 brackets for calibrating E-Steps on the X & Y axis. A Z axis bracket can be found on thingiverse that was already made by someone else.
Use the Ender's controls to move each axis. Write down the dial indicator's readings and perform the appropriate math to re-calibrate your e-steps.
Print how you see fit.
If need be, i can upload the MM to inch measurements and math on how to change E-step calibration.
Paying it forward to the community.
Feel free to donate for a coffee.
Use the Ender's controls to move each axis. Write down the dial indicator's readings and perform the appropriate math to re-calibrate your e-steps.
Print how you see fit.
If need be, i can upload the MM to inch measurements and math on how to change E-step calibration.
Paying it forward to the community.
Feel free to donate for a coffee.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
