[Ender 3 / Ender 3 pro] SPOOLHOLDER

This is an improved version (in my opinion) based on "Creality (Ender 3) Filament holder 80mm spools"
by mjoaris November 11, 2018
https://www.thingiverse.com/thing:3209211

I designed this with printability in mind - no supports needed and fast printing. I also took advantage of the layer orientation which made the base part much stronger.



Additional Hardware:
M5x16 screw (you could add some spacers if you want to use longer screws)
M5 hex nut
608 ball bearing (you will need 2 of these)

Assembly is shown in the pictures
!!! The assembly picture shows an older version, but the assembly is still the same !!!

I might make a printable screws version If the demand is big enough