Thingiverse

Ender 3 External Electronics Case (Enclosure Mounted) – Bild 1

Ender 3 External Electronics Case (Enclosure Mounted) – Bild 2

Ender 3 External Electronics Case (Enclosure Mounted) – Bild 3

Ender 3 External Electronics Case (Enclosure Mounted)

von BMacIntosh

1.5k Downloads

982 Likes

1 Makes

Zum Modell

A remix of https://www.thingiverse.com/thing:3631413 by MrClown. While the original case is intended as a standalone unit, this remix is intended to be mounted on top of an enclosure such as a Lack enclosure, with all the wires running down through holes in the surface below (I used a single 1.25" hole lined with a short length of loom tubing). Three short wood screws can attach the enclosure to the surface.

Changes:
* Removed original cable ports.
* Added screw holes in base for mounting to a surface
* Added a large hole in the bottom for wires
* Tweaked depth of fan slot
* Reduced wall width around USB slot
* Slightly thinner walls
* Rounded corners and added mouse ears to combat curling

See also my external Lack PSU mount: https://www.thingiverse.com/thing:5146016.

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat