Ender 3 EZOUT V2 Sensor Mount

This is a filament guide and mount for the EZOUT V2 sensor designed for an Ender 3. This will fit on any similar printer.

I sliced this in Cura 5.2 and printed it on an Ender 3 V2 Neo.

I used .2mm layer and 25% infill. The infill can be lower, but 25% gives an extremely strong result. Supports are optional for the tapered whole at the bottom, which is a 45˚ angle so it should print fine without supports.

Bracket mounts with two M5 x 8mm button head screws and two M5 T Slot nuts. The sensor mounts with two M3 x 20mm button head screws optionally finished off with two M3 nuts.