Thingiverse
Ender 3 Filament Guide
door redux703
4
Downloads
4
Likes
0
Makes
All you need is;
- 608 bearing
( Inside diameter: 8mm, Outside diameter: 22mm, Thickness: 7mm)
- M3x25 ish screw
I used a way too long screw I had laying around so please don't hate.
You need to print the following parts:
1x holder_2
1x holder
1x Bearing_Holder
2x Bearing_Holder1
Maybe a handy tip is pre thread the Bearing_Holder1 before installing the whole assambly.
There are also the .IPT files so if you want to adjust it, it might be easier that way
- 608 bearing
( Inside diameter: 8mm, Outside diameter: 22mm, Thickness: 7mm)
- M3x25 ish screw
I used a way too long screw I had laying around so please don't hate.
You need to print the following parts:
1x holder_2
1x holder
1x Bearing_Holder
2x Bearing_Holder1
Maybe a handy tip is pre thread the Bearing_Holder1 before installing the whole assambly.
There are also the .IPT files so if you want to adjust it, it might be easier that way
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
