Thingiverse
Ender 3 Filament Guide
von Mankokimochi
11
Downloads
5
Likes
0
Makes
A simple filament guide for Ender 3 series. (3, 3 pro, 3 V2).
Installation method as shown in the picture. The old design caused problems, especially friction. Changing to PTFE tube ensures there are minimum friction, and it will last like a long time. You need to sacrifice a little bit of PTFE tube (~30mm is enough). It's a little bit tight when fitting the PTFE tube.
Recommended settings
infill >30%
layer height 0.2mm or lower
print orientation : as is with supports from build platform only
or rotated 90 degrees (the tube parallel with Z axis) with supports
Installation method as shown in the picture. The old design caused problems, especially friction. Changing to PTFE tube ensures there are minimum friction, and it will last like a long time. You need to sacrifice a little bit of PTFE tube (~30mm is enough). It's a little bit tight when fitting the PTFE tube.
Recommended settings
infill >30%
layer height 0.2mm or lower
print orientation : as is with supports from build platform only
or rotated 90 degrees (the tube parallel with Z axis) with supports
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
