Thingiverse
Ender 3 Filament Guide
por gareth8118
1
Descargas
0
Likes
0
Makes
Filament guide for the Ender 3 Pro.
I could not get a 608 bearing ontom nor an M3 bolt into the original model, so I reduced the OD of the peg for the bearing from 7.99mm to 7.88mm, and I created a hole for an M3 brass insert for the retainer. Pulley half and retainer both are unchanged from the original.
I could not get a 608 bearing ontom nor an M3 bolt into the original model, so I reduced the OD of the peg for the bearing from 7.99mm to 7.88mm, and I created a hole for an M3 brass insert for the retainer. Pulley half and retainer both are unchanged from the original.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
