Thingiverse
Ender 3 filament guide wheel
von Ekeberg
27
Downloads
20
Likes
0
Makes
Filament guide for the Ender 3 to steer the filament gently into the extruder.
A 608 ball bearing is fitted between the two wheel sides. Four M3x10 screws with nuts hold the sides together. The two wheel parts are identical, except that one has pockets för nuts while the other for the screw heads.
The mount arm is fitted on top of the X-motor. You will need a longer M4 screw to secure the inner part of the ball bearing to the arm.
Support is needed for this to print properly.
A 608 ball bearing is fitted between the two wheel sides. Four M3x10 screws with nuts hold the sides together. The two wheel parts are identical, except that one has pockets för nuts while the other for the screw heads.
The mount arm is fitted on top of the X-motor. You will need a longer M4 screw to secure the inner part of the ball bearing to the arm.
Support is needed for this to print properly.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
