Thingiverse
Ender 3 Floating Tools Tray
von JPGrox
26
Downloads
14
Likes
0
Makes
+ I wanted to clear my printer desk from all the scattered tools, so I came up with this design that can hold all the tools that were included with my Ender 3 pro and some others I frequently use.
+ Given that the tools will hang from the tray it's important to have the printer located on the side edge of the table (left side of the printer is the best location, because the right is occupied by the screen)
+ The hook that connects with the printer rail holds the tray very well. I'm not familiar with the Ender 5 and CR-10 rails, but if they are the same than in the Ender 3, then it should work perfectly as well.
+ It's important to add a custom support in the rail hook section, to prevent the printer from printing on thin air (as shown in the 5th picture)
+ Once I printed the first version (V1 STL) I noticed that I had room left to add some more tools, so then I came up with V2, it's pretty much the same as V1, but it adds:
→ † 3 more MicroSD slots
→ † 2 more Nozzles
+ Given that the tools will hang from the tray it's important to have the printer located on the side edge of the table (left side of the printer is the best location, because the right is occupied by the screen)
+ The hook that connects with the printer rail holds the tray very well. I'm not familiar with the Ender 5 and CR-10 rails, but if they are the same than in the Ender 3, then it should work perfectly as well.
+ It's important to add a custom support in the rail hook section, to prevent the printer from printing on thin air (as shown in the 5th picture)
+ Once I printed the first version (V1 STL) I noticed that I had room left to add some more tools, so then I came up with V2, it's pretty much the same as V1, but it adds:
→ † 3 more MicroSD slots
→ † 2 more Nozzles
JPGrox veröffentlicht auch auf
1 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
