Ender 3 Klicky Probe

This is a klicky probe for the Ender 3 V2. I was heavily inspired by the KlackEnder by KevinAkaSam (https://github.com/kevinakasam/KlackEnder-Probe).

My printer has linear rails which prevented the KlackEnder from working with my setup. Also, I was unable to get consistent results with only 2 magnets and found 3 to be far better. This design is based on the UniTak3d Direct Drive Upgrade kit. It could work with other's but I am not sure.

To assemble I used a M5 bolt through the carriage and X Axis Mount with a nut on the mount side. This prevents the mount from moving and greatly increases the accuracy of the probe. The Holder uses M5 bolts/T-nuts and mounts to the right gantry.

It is a tight fit and you may need to take a file to some areas.

The probe/mount uses 6ea 6x3mm magnets. I prefer to solder directly to the magnets and have not noticed a reduction in their performance. I set it up where the 2 magnets making the electrical connection are facing the same way