Thingiverse
Ender-3 LCD Display Stand
por _Marius
5.1k
Descargas
3.9k
Likes
14
Makes
Ender-3 Display Stand
As I prefer the printer electronics not beeing baked in the IKEA LACK cupboard, I relocated mainboard, power supply and display outside the LACK using a long ribbon cable.
My first try designing a display stand ended in something like a brick (can be seen in my other designs)
This cover here is slim, looks better and can be assembled without glue or screws.
!! PLEASE NOTE: For fitting in the intentionally slim design, the plug of the original display cable might be too tall (see chapter post-printing below). Before printing (and commenting) please check, whether this is the case. If so a buying a smaller plug or an extension cable with small plugs (see example Link below) will solve the issue.
ORDER OF ASSEMBLY:
1.) Slide in display (with attached cable) in the main frame
2.) put loose cable end through the holes
3.) install cable plug from the inside (if it is too loose a drop of glue will help)
4.) slide in the left side (the one with the
As I prefer the printer electronics not beeing baked in the IKEA LACK cupboard, I relocated mainboard, power supply and display outside the LACK using a long ribbon cable.
My first try designing a display stand ended in something like a brick (can be seen in my other designs)
This cover here is slim, looks better and can be assembled without glue or screws.
!! PLEASE NOTE: For fitting in the intentionally slim design, the plug of the original display cable might be too tall (see chapter post-printing below). Before printing (and commenting) please check, whether this is the case. If so a buying a smaller plug or an extension cable with small plugs (see example Link below) will solve the issue.
ORDER OF ASSEMBLY:
1.) Slide in display (with attached cable) in the main frame
2.) put loose cable end through the holes
3.) install cable plug from the inside (if it is too loose a drop of glue will help)
4.) slide in the left side (the one with the
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
